close

How to solve UnicodeDecodeError in Python 3.6?

Hello Guys, How are you all? Hope You all Are Fine. Today We Are Going To learn about How to solve UnicodeDecodeError in Python 3.6 in Python. So Here I am Explain to you all the possible Methods here.

Without wasting your time, Let’s start This Article.

Table of Contents

How to solve UnicodeDecodeError in Python 3.6?

  1. How to solve UnicodeDecodeError in Python 3.6?

    locale depends on LANG being set properly. Python effectively uses locale to work out what encoding to use when writing to stdout in. If it can't work it out, it defaults to ASCII.

  2. solve UnicodeDecodeError in Python 3.6

    locale depends on LANG being set properly. Python effectively uses locale to work out what encoding to use when writing to stdout in. If it can't work it out, it defaults to ASCII.

Method 1

It sounds like your locale is broken and have another bytes->Unicode issue. The thing you did for Python 2.7 is a hack that only masked the real problem (there’s a reason why you have to reload sys to make it work).

To fix your locale, try typing locale from the command line. It should look something like:

LANG=en_GB.UTF-8
LC_CTYPE="en_US.UTF-8"
LC_NUMERIC="en_GB.UTF-8"
LC_TIME="en_GB.UTF-8"
LC_COLLATE="en_GB.UTF-8"
LC_MONETARY="en_GB.UTF-8"
LC_MESSAGES="en_GB.UTF-8"
LC_ALL=

locale depends on LANG being set properly. Python effectively uses locale to work out what encoding to use when writing to stdout in. If it can’t work it out, it defaults to ASCII.

You should first attempt to fix your locale. If locale errors, make sure you’ve installed the correct language pack for your region.

If all else fails, you can always fix Python by setting PYTHONIOENCODING=UTF-8. This should be used as a last resort as you’ll be masking problems once again.

If Python is still throwing an error after setting PYTHONIOENCODING then please update your question with the stacktrace. Chances are you’ve got an implied conversion going on.

Method 2

I had this issue when using Python inside a Docker container based on Ubuntu 18.04. It appeared to be a locale issue, which was solved by adding the following to the Dockerfile:

ENV LANG C.UTF-8

Summery

It’s all About this issue. Hope all Methods helped you a lot. Comment below Your thoughts and your queries. Also, Comment below which Method worked for you? Thank You.

Also, Read