close

[Solved] urllib3 connectionpool – Connection pool is full, discarding connection

Hello Guys, How are you all? Hope You all Are Fine. Today I get the following error urllib3 connectionpool – Connection pool is full, discarding connection in python. So Here I am Explain to you all the possible solutions here.

Without wasting your time, Let’s start This Article to Solve This Error.

How urllib3 connectionpool – Connection pool is full, discarding connection Error Occurs?

Today I get the following error urllib3 connectionpool – Connection pool is full, discarding connection in python.

How To Solve urllib3 connectionpool – Connection pool is full, discarding connection Error ?

  1. How To Solve urllib3 connectionpool – Connection pool is full, discarding connection Error ?

    To Solve urllib3 connectionpool – Connection pool is full, discarding connection Error The connection is being discarded after the request is completed (because the pool is full, as mentioned). This means that this particular connection is not going to be re-used in the future.

  2. urllib3 connectionpool – Connection pool is full, discarding connection

    To Solve urllib3 connectionpool – Connection pool is full, discarding connection Error The connection is being discarded after the request is completed (because the pool is full, as mentioned). This means that this particular connection is not going to be re-used in the future.

Solution 1

No data is being lost!

The connection is being discarded after the request is completed (because the pool is full, as mentioned). This means that this particular connection is not going to be re-used in the future.

Because a urllib3 PoolManager reuses connections, it will limit how many connections are retained per hos to avoid accumulating too many unused sockets. The PoolManager can be configured to avoid creating excess sockets when the pool doesn’t have any idle sockets available with PoolManager(..., block=True).

If you’re relying on concurrency, it could be a good idea to increase the size of the pool (maxsize) to be at least as large as the number of threads you’re using, so that each thread effectively gets its own connection.

Solution 2


According to the documentation on Customizing Pool Behavior, neither of your interpretations are correct:

By default, if a new request is made and there is no free connection in the pool then a new connection will be created. However, this connection will not be saved if more than maxsize connections exist. This means that maxsize does not determine the maximum number of connections that can be open to a particular host, just the maximum number of connections to keep in the pool.

(my emphasis)

So connections were not aborted to be retried later. They were made immediately, as requested, and results returned. Then, after they have completed, those “extra” connections were discarded, i.e., they were not kept in the pool for later reuse.

For example, if your maxsize is 10 (the default when using urllib3 via requests), and you launch 50 requests in parallel, those 50 connections will be performed at once, and after completion only 10 will remain in the pool while 40 will be discarded (and issue that warning).

Summery

It’s all About this issue. Hope all solution helped you a lot. Comment below Your thoughts and your queries. Also, Comment below which solution worked for you? Thank You.

Also, Read